Pool Equipment Installation in Scottsdale, AZ

We install equipment from the major brands Scottsdale pools run, including Pentair, Hayward, Jandy, and Zodiac, for pumps, filters, heaters, and automation systems. We carry the common unions, fittings, and electrical connectors on the truck so a lot of installs finish in one visit instead of a second trip. When an older setup needs an adapter or a plumbing change to fit modern equipment, we handle that as part of the install rather than leaving it for later. We never force a unit onto plumbing it was not designed for.

For plumbing we work with standard PVC and schedule 80 fittings, union connections, and the glue and primer rated for pool pressure lines, plus the electrical conduit and connections rated for wet outdoor conditions. Scottsdale heat and sun break down exposed plastic and wiring fast, so we route and protect the new equipment to last. If your pool needs a variable speed pump upgrade for efficiency, we size it to your plumbing so you get the savings without losing flow. We give a free written quote after seeing the pad and the setup so you know the full scope.

Pool automation systems let you run the pump, heater, lights, and features from a phone or a control panel instead of walking out to the pad every time. We install and set up automation from Pentair IntelliTouch and EasyTouch, Hayward OmniLogic, and Jandy AquaLink, pairing the system to your equipment so the schedules run clean. A modern automation upgrade is often the right move when an old mechanical timer is failing, since it gives you remote control and better energy management at the same time. We size the control to the number of devices on your pool so you are not paying for channels you will never use.

We also handle the wiring, the relays, and the sensor setup that make automation actually work, because a control panel that is wired wrong will cycle the pump and heater at the wrong times and show up as cloudy water a few days later. Scottsdale heat means a lot of pools run heaters and variable speed pumps on schedules, so getting the automation paired correctly matters more than just mounting the box. We give a free written quote after seeing the pad and the existing wiring, with the full scope laid out before any work begins. For related control and timer fixes, see our pool repair page.

We do not push a new install when a repair will get years more life out of your current equipment. We diagnose the actual failure first, whether it is a bad capacitor, a worn seal, or a burned contact, and we quote the repair in writing before we touch anything. If the unit is still serviceable and the rest of the setup is sound, we fix it and stand behind the work with our satisfaction guarantee. A rebuilt pump or a replaced valve often runs for a fraction of what a full install would cost.

When a unit is past repair, or when an upgrade like a variable speed pump or automation system makes more sense, we say so plainly and quote an install sized and matched to your pool and plumbing, never a bigger unit than you need. We give a free written quote after seeing your situation, no pressure, and we lay out the repair option and the replace option side by side so you can choose. We never swap a whole unit just to run up the bill, and we will not sell you an install we would not put on our own pool.